These clamps have twice the capacity of standard fast-action bar clamps.

Pull the handle to lock the jaw in place and prevent loosening caused by vibration.

Hold up to five times the capacity of standard bar clamps. These are also known as I-beam clamps.

All adjustments can be made from one end, allowing clamping in tight spaces.

The large, flat jaws remain parallel when clamping to apply even pressure without denting or marring the workpiece. Pull the handle to lock or release the clamping arm.

Press the trigger to slide the clamping arm along the bar. Release the trigger and squeeze the pistol‐grip handle to lock the clamp in place.

Clamp much farther in from the edge of the workpiece than with standard bar clamps.

Two swivel pads on each jaw pivot to grip nearly any shape of material.

The handle locks in a horizontal position for more clearance above the clamp than standard hold-down toggle clamps.

Reduce the chance of getting pinched when unclamping. These clamps have more space between the handle and the arm than other low-profile toggle clamps.

Hold workpieces of slightly different thicknesses with one clamp. These clamps automatically adjust to compensate for imperfections or small inconsistencies on the material’s surface.

Push the lever to lock the handle and prevent accidental opening.

Push the lever to lock the handle and prevent accidental opening.

Weld these clamps to the side of an object or drill your own holes in the mounting plate and bolt into place.

Attach one of these nonmarring rubber or plastic tips to prevent a metal holding screw from damaging workpiece surfaces.

These clamps have mounting holes on the bottom.

Turn the handle to tighten these multipurpose tools for strong clamping in nearly any application.

These clamps are made of stainless steel for excellent corrosion resistance.

All components of these clamps are made of aluminum-bronze that is Factory Mutual approved. They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Made entirely of fiberglass, these clamps won’t transmit electricity and are chemical resistant. They're often used around electrical equipment as well as in plating and anodizing applications.

Clamp farther in from the edge of a workpiece than with other C-clamps.

The clamp body is extra-slim to fit into narrow openings.

Hold the workpiece down against a bench or table.

Apply pressure to the side of a workpiece as well as the top and bottom.

Push or pull the plunger to hold your workpiece from the side.

The handle can be rotated 125° for easier access or extra clearance above the clamp.

Moving parts are protected by a metal cover when the clamp is engaged to prevent dirt and dust from clogging the clamp.

Smaller than standard push toggle clamps, these are often used for electronics and small fixturing applications.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

Slide the upper jaw to adjust the opening size. These clamps hold larger workpieces than other locking plier clamps of similar size.

Squeeze the handles to open the clamp; release and the spring holds it tightly in place.

Hold large workpieces with a standard-size clamp. Slide the jaws to adjust the opening size.

Press the lever to lock the clamp onto material.

Attached to an arm you can flex into position, these clamps hold objects such as a flashlight, tool, or instructions.

Clamp thin sheet material together without drilling holes. These clamps open with special pliers and spring closed when the pliers are released.

Clamp up to three workpieces at 90° angles.

With five times the capacity of standard corner clamps, these secure two workpieces at a 90° angle.

Push the lever to lock the handle and prevent accidental opening.

Push the lever to lock the handle and prevent accidental opening.

Mount using the holes in the base.

The matching jaws are ground flat for a firm grip and even pressure when clamping smooth surfaces.