Prevent clogs that wear the bit and slow down drilling. The flutes on these bits have an open design that pulls chips out of the hole faster than standard spiral flutes. Also known as pole or ship auger bits, they are used to cut deep holes through lumber, railroad ties, and utility poles.

Drill, countersink, and drive screws without switching three separate bits in and out of your power tool. With a single hand, flip between drilling countersunk holes and driving screws. The countersinking drill and screwdriver bit are secured with set screws, so you can switch them out for any bits with a _1/4” hex shank.

The countersinking drill has an 82° angle, allowing inch-sized flat- and oval-head screws to sit flush with the surface.

Center holes perfectly before installing hinges, latches, and other hardware that require a countersunk screw. These bits have a built-in guide with a beveled tip that keeps the bit in position as it enters the material. So instead of measuring and marking, use your hardware as a template to drill the pilot holes. Once screws are installed, they're straight and the heads are flush. Also known as Vix bits, they're made of wear- and heat-resistant high-speed steel.

Fasten differently sized screws with these sets. They save you the effort of switching three separate bits in and out of a power tool, instead letting you flip between a countersinking drill and a screwdriver bit with a single hand. You can also attach your own countersinking drills and screwdriver bits as long as they have a _1/4” hex shank.

Countersinking drills have an 82° angle, allowing inch-sized flat- and oval-head screws to sit flush with the surface.