The dials on these vises are graduated in smaller increments than standard cross‐slide drill‐press vises for finer adjustment. Use to precisely position work on X and Y axes.

Turn the handle to move the jaw on these basic vises.

Tilt and lock the vise to hold work at any angle up to 90°.

Arrange the included pins in a series of holes to position a part at any angle and hold odd-shaped parts securely.

Hold workpieces steady with these vise jaws—they work with slot-mount workstops so you can quickly position, adjust, and change out your workpieces.

Quickly move parallels in and out of these jaws to raise your workpiece within the vise. Mount jaws to the vise, slide the mating parallels in place, and rest your workpiece on top.

Made from unhardened aluminum or steel, machine these jaws to fit the contours and curves of your workpiece.

The vise body and stationary jaw are one piece for high repeatability, even under heavy clamping loads. Ground flat on the base and three sides, these vises ensure accuracy whether mounted on the base, either side, or upright.

Store vise handles near your milling machine.

Mount to a machine table to rotate a vise 360° in 1° increments.

Designed to hold your part on 4- and 5-axis milling machines, these vises provide rigid clamping while exposing five full sides of the workpiece. This allows even complex parts to be completed in a single operation. You must cut a dovetail into your material before the vise can grip it.

The jaws move inward at the same time to consistently position your workpiece in the center of the vise.

Compressed air controlled by a foot pedal allows hands‐free operation. Use these vises in production applications with frequent insertion and removal of workpieces.

Keep parts in position for machining by mounting these workstops to your vise jaws.

The entire surface of these plates is magnetic to provide a powerful hold for grinding, drilling, and electrical discharge machining (EDM). Pull the handle to switch the magnets on and off.

Two vise heads tilt and rotate 360°, locking in place to hold work at any angle.

For large workpieces, these vises open three times as wide as standard tilting-head vises. Tilt and lock the head to position work at an angle.

Use these vises for general purpose workholding.

A bright yellow vise body stands out on the shop floor.

The movable jaw can be repositioned to extend the jaw opening. Pull out the entire sliding section and insert it on the opposite side of the vise.

Made of 304 stainless steel to stand up to washdown environments, such as food and beverage production, these are the most corrosion-resistant vises we offer.

Replace worn flat and V jaws.

Also known as woodworkers' vises, these mount to the underside of your workbench and sit flush with the surface.

Choose from flat and grooved liners.

These V-shaped liners hold large round material.

Arrange the pins in a series of holes to grip parts with angled or uneven sides.

Sets include four vises with different opening sizes. A hollow body allows wires and rods to pass through.

Clamp and unclamp with one hand by sliding the knurled ring forward to close the collet.

Notches on the jaws hold round material on its outside diameter.

Three chuck‐style jaws clamp around your part.

Squeeze the body to open the flat jaws; release to grip.

Build a custom clamping system for holding lightweight objects such as beakers and laboratory equipment.

Set up the tripod wherever you need to work.

Steel jaws secure round workpieces such as pipe, tubing, and conduit.