Internal mounting bosses or mounting brackets enable you to use panels or DIN rail to mount components. Enclosures are made of nonconductive polycarbonate that resists denting, chipping, and cracking.

These enclosures have thicker walls than standard aluminum enclosures, but are still a lightweight yet durable alternative to stainless steel.

Stainless steel enclosures are more corrosion resistant than aluminum for use in environments with corrosive liquids.

With a hygienic design, these enclosures minimize spots where food, debris, and water could collect after washdowns. Use them to house and mount switches, buttons, and other components in sanitary environments.

Mounting feet make attachment to machines and walls hassle-free.

Internal mounting bosses or mounting brackets enable you to use panels or DIN rail to mount components. These enclosures have a clear cover, so you can inspect components without opening the enclosure.

Mounting feet make attachment to machines and walls hassle-free. These enclosures are small and lightweight for use with sensors, switches, testing devices, and circuit boards.

Control access to these enclosures with a key-operated lock.

Made of fiberglass, these enclosures are lightweight and won’t rust, but still shield push-button controls from water, dirt, and oil.

Protect electronics from washdowns in food plants and other sanitary environments. These enclosures have standard-size push-button holes, saving you the effort of measuring and cutting holes yourself. A shroud hangs over the holes to guard buttons from damage and accidental pushing.

Protect electronics from washdowns in food plants and other sanitary environments. These enclosures mount directly into walls to protect wiring and reduce the surface area that needs to be cleaned. Standard-size push-button holes are already installed, saving you the effort of measuring and cutting holes yourself.

These enclosures withstand temperatures up to 475° F.

Keep electronics safe from harmful contact with hands and tools while still allowing air and moisture to enter.

Choose a body and two matching end caps to make your own dust-tight or watertight enclosure.

House electrical components in these general purpose enclosures.

Made of nonconductive polycarbonate, these enclosures withstand prolonged submersion in water while protecting electronics from dents, chips, and cracks.

Able to withstand periodic submersion in water, these enclosures offer our highest level of protection from liquids. They’re made of fiberglass to resist impact and corrosion from solvents, alkalis, and mild acids.

Internal mounting bosses or mounting brackets enable you to use panels or DIN rail to mount components.

Check on the contents inside these enclosures from every angle without opening them in wet environments.

Mount these enclosures directly to machine control panels in wet environments and view the contents without opening them.

Holes in the cover allow easy installation of push buttons, switches, and indicating lights.

Holes in the cover of these enclosures allow easy installation of push buttons, switches, and indicating lights.

Make your push buttons, switches, and indicating lights more visible and ergonomic to use. Enclosures mount on either of two sides, creating a 30° or 60° slanted surface.

Made of aluminum, these enclosures resist corrosion from rain, sleet, and snow. While not as corrosion resistant as stainless steel, aluminum is lighter for better mobility, and also easier to machine for custom mounting.

With an overhanging top and a NEMA 3RX rating, these enclosures guard electronics from snow, rain, and sleet as well as dirt and light splashing.