Use these bearings in applications with frequent starts and stops because they operate with very little friction.

These bearings stand up to a wider range of chemicals than other dry-running sleeve bearings.

Made of FDA-listed materials or FDA compliant, these bearings are for use in food applications. They also withstand caustic and washdown environments.

Reinforced with polyester fabric, these plastic bearings have load and speed capabilities comparable to metal bearings.

Good for underwater applications, these bearings won’t swell or warp when wet.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

A metal backing adds strength.

Handle heavy loads that frequently start and stop along shafts—these bearings contain extra iron and slippery PTFE lubricant. They’re thrust bearings, which means they support loads parallel to the shaft.

Made from slippery materials, these bearings reduce friction without the oily mess.

Ridges on the inside of these bearings wipe away dust and debris as the bearing travels on a shaft.

Made of FDA-listed materials for use in food applications, these bearings also have excellent chemical and corrosion resistance.

Sleeve bearings outperform ball bearings in dirty environments. Use them for low speed applications.

Virtually maintenance free, these bearings have slippery, chemical-resistant liners that don't require added lubrication.

The Frelon liner on these bearings allows them to stand up to a wider range of chemicals than other flange-mounted linear sleeve bearings.

With two bearings mounted in one housing, these sleeve bearings withstand heavy loads. Use them on round support rail shafts for applications that require maximum rigidity.

A slippery PTFE liner reduces wear and eliminates the need for lubrication.

Made of stainless steel, these internally threaded rod ends provide excellent corrosion resistance.

These anodized aluminum rod ends are lighter than stainless steel rod ends and have good corrosion resistance. Internal threads mate with rod end bolts, threaded rods, and other components with male threads.

A carbon fiber-reinforced insert or PTFE liner reduces wear, handles shock loads, and eliminates the need for lubrication.

With at least 55° of ball swivel, these rod ends accommodate greater misalignment than any other internally threaded rod end we offer.

Made of cadmium-plated steel, these internally threaded rod ends generally handle higher loads than stainless steel, aluminum, and nylon rod ends.

These internally threaded steel rod ends handle loads that are at least 25% higher than other comparably sized rod ends.

A slippery PTFE liner reduces wear and eliminates the need for lubrication.

A handle on the side of the carriage locks the carriage in place.

With a wide base, these sleeve bearing carriages stabilize moment (twisting) and off-center loads better than standard carriages. Use in areas where multiple carriages or rails won't fit.

For applications with low clearance, these carriages protrude less than 5 mm above their rails.

Made with Frelon bearings, these slides have over four times the load capacity of standard positioning slides.

A layer of tin-plated steel adds structural support and makes this PTFE easy to form.