Minimize damage to your work surfaces with these brass punches, which are softer than steel punches.

The rounded tip of these punches fits into the open ends of hollow and spring pins to protect them from damage during removal.

Loosen pins and rivets before removal.

Contains pin-loosening, pin-removal, and center-marking punches.

Use alignment pins to align structural components such as I-beams and angle iron for bolting, riveting, and welding.

Sets include three punches in various point diameters to set nails flush or drive them out of view without damaging wood surfaces.

Sets include common ID and OD sizes to create gaskets and washers in two strikes.

For accurate punching of inner and outer holes, these sets come with pilots that attach to the outer hole punch.

Screw one of the interchangeable heads into the included handle to create holes up to 3/16" dia. in tight spaces.

The driver supplies eight tons of force to the hole punches in this set to make straight punches.

Create larger holes and make repeated punches with these drivers that supply 11 tons of force to the included hole punches.

The included hydraulic driver allows you to punch conduit up to size 2.

Includes all six sizes of our individually sold hand-driven hole punches plus a tool to remove punched out material.

Our strongest punch, this tool has 35 tons of force to punch through tough materials such as bus bars, railings, and I-beams.

These sets come with three punches for use with a variety of hole sizes. Insert one into an existing hole and twist the handle to open the end of the punch. The point automatically centers once the punch has fit the hole size.

The punches in these sets have a uniform shoulder height so you can quickly transfer multiple hole locations at once. Also known as transfer screws.

Use the Starrett punches in these sets to mark hole centers in metal and other materials. Also known as center punches.

Punch has two viewing lenses. One has a circle and dot and one has a crosshair to enable you to pinpoint the location where you need to punch. Replace the lens with one of the two included punches and strike it with a hammer to mark the hole center.