These pins combine the locking capabilities of a clevis pin with the precision diameter of a dowel pin for a tight fit.

A large loop handle makes these pins easy to grip.

These pins have multiple through holes; change the length by moving the cotter pin. The bend makes them easy to insert and pull out.

Easier to install and remove than standard clevis pins, these pins have a ring-grip handle.

The wire retainer snaps closed to secure the pin for a one-piece alternative to a clevis and cotter pin combination. Also known as PTO pins.

Install or remove these pins from either side. Slide a retaining ring into the groove for a secure hold that takes up less space than a cotter pin.

Sized to fit snugly around pipe and tube, these pins use spring force to keep the retainer closed.

A spring holds these pins tight, while a toggle locks them in place. Flip the toggle to release the pin.

These one-piece fasteners lock in place with a toggle. Flip the toggle to release the pin.

Often used to connect equipment to a drawbar in towing applications, these rugged pins have a welded solid steel retainer.

A coil makes a stronger grip than standard hairpin cotter pins to prevent accidental release.

These pins are coiled for more tension than standard wire-snap cotter pins.

Also known as split pins, these have one prong slightly longer than the other so they’re easy to open. Bend prongs outward to secure.

An extra loop locks these cotter pins more securely than other pins, so they can't vibrate out or be knocked off.

For parts that spin or are otherwise difficult to access, slide these pins in and tap them with a hammer for a temporary hold. Reposition work, then bend the prongs outward to secure.

These pins have a low-profile head, so they won't get knocked out of place. A spring-loaded, nonlocking retaining ball pops out when the pin is pushed through a hole, and retracts when the pin is pulled out.

The smooth ring handle on these pins won't catch on parts. The shoulder keeps a portion of the pin outside the hole and makes them easy to grab.

These pins adjust to take up play in a system or hold parts in holes of varying thicknesses. Spin the handle up or down, then tighten the locknut to change the length by up to ½”. Pins lock in place until you push the button to release the spring-loaded retaining balls.