Hook into your roller chain and use the handle to tighten the jaw until the chain ends are close enough to add or remove a link. Choose from holders with maximum jaw capacity from 1 3/4” to 5”.

Drive out chain pins with a twist of the handle.

In addition to breaking chain, these tools can also rivet chain to increase strength for better performance on high-speed drives.

Twist these tools on the spring-clip to remove it.

Place these steel inserts between two roller links. If they can be inserted past your ANSI number, the chain is worn out.

Also known as captured guides, deep-channel guides prevent chain from slipping off track.

Install these rings between strands of chain to absorb slack without the need for realignment, lubrication, or tools—good for use in confined spaces where maintenance may be difficult.

These tensioners range in height from 5 15/32" to 7 25/32".

At less than 4" in height, these tensioners are good for use on low-clearance drives.

Apply continuous tension and automatically take up slack at any point in a 180° arc.