Screw the pin into position by hand for quick installation and removal. They're for use in low-vibration applications where the shackle remains stationary.

Pop the clevis pin in to install these hooks, no extra fittings needed.

These clamps have a forged fabrication and are reliable in critical applications. They are not for making slings. These must be oriented with the saddle on the long (live) end and U-bolt on the short (dead) end. They’re also known as wire rope clips.

Install these clamps without any specific orientation, slide the nut over the rope and tighten it onto the threaded halves with a torque wrench.

Kits include clamps and thimbles to support a wire rope loop and prevent it from fraying. Clamps must be oriented with the saddle on the long (live) end and U-bolt on the short (dead) end.

Create a loop by feeding the wire rope through the clamp and tighten the set screw to secure it in place. Loosen the set screw to quickly adjust the loop. Also known as Gripple rope clamps. They are for use in noncritical applications, such as fencing.

Also known as standard-pattern thimbles, these provide better protection against fraying than light duty thimbles.

The open-end design leaves more room for connections than other thimbles.

Use these sleeves for non-lifting applications such as tethering, securing, and suspending.

Keep multiple sleeves on hand in a variety of sizes.

Install these stud-end plug-lock fittings on the end of wire rope for a strong hold and finished appearance.

Use a new plug when installing a fitting on a different rope.

Place the wire rope and sleeve through a hole in the assembly block and tighten into a vise to hold. Then attach the plug driver on the end of a plug to make hammering in the plug easier.

Also known as socket-end swage fittings, install these ball-with-shank-end fittings with a roller swage press for a strong, permanent hold.

Also known as socket-end swage fittings, install these stud-end fittings with a roller swage press for a strong, permanent hold.

Add an eye-end to wire rope without having to fray the rope or use a compression tool.

Add a stud end to wire rope without having to fray the rope or use a compression tool.

Feed the wire rope into the opening at the bottom of these eye-end fittings and through the body for a quick and simple installation.

Compress the thin shank wall with a hand tool to attach these light duty clevis-end fittings. They are also known as hand swage fittings.

Compress the thin shank wall with a hand tool to attach these light duty eye-end fittings. They are also known as hand swage fittings.

Make a removable loop without specialty tools–secure the two halves of these clamps with a screwdriver and the included screws.