These clamps have a forged fabrication and are reliable in critical applications. They are not for making slings. These must be oriented with the saddle on the long (live) end and U-bolt on the short (dead) end. They’re also known as wire rope clips.

Install these clamps without any specific orientation, slide the nut over the rope and tighten it onto the threaded halves with a torque wrench.

Make a removable loop without specialty tools for use in noncritical applications, such as fencing. Also known as tiller clamps.

Use in noncritical applications, such as fencing, where the strength of a forged clamp is not required. Install clamps so the saddle is on the long (live) end and the U-bolt is on the short (dead) end. They’re also known as wire rope clips.

Use these sleeves for non-lifting applications such as tethering, securing, and suspending.

Keep multiple sleeves on hand in a variety of sizes.

Also known as heavy-pattern thimbles, these can be used to reinforce the loop of a sling.

The open-end design leaves more room for connections than other thimbles.

Use a new plug when installing a fitting on a different rope.

Install these eye-end plug-lock fittings on the end of wire rope for a strong hold and finished appearance.

Place the wire rope and sleeve through a hole in the assembly block and tighten into a vise to hold. Then attach the plug driver on the end of a plug to make hammering in the plug easier.

Also known as socket-end swage fittings, install these eye-end fittings with a roller swage press for a strong, permanent hold.

Also known as socket-end swage fittings, install these clevis-end fittings with a roller swage press for a strong, permanent hold.

Add an eye-end to wire rope without having to fray the rope or use a compression tool.

Add a mounting-plate to wire rope without having to fray the rope or use a compression tool.

Feed the wire rope into the opening at the bottom of these eye-end fittings and through the body for a quick and simple installation.

Compress the thin shank wall with a hand tool to attach these light duty mounting-plate-end fittings. They are also known as hand swage fittings.

Compress the thin shank wall with a hand tool to attach these light duty stud-end fittings. They are also known as hand swage fittings.

The swivel fork ends allow the lanyard to rotate freely.

Made to meet stringent military standards, the fittings on these lanyards meet MS 20668 and MS 21259.

Attach to a threaded anchor or hole for support and use the loop to secure the suspended material.

Create a choker loop around a supporting structure with the snap-hook end and use the loop to secure the suspended material.

A large opening combined with an easy to open latch allows for quick and easy attachment to links and rings.

Attach the 90° eye to a surface for support and use the loop to secure the suspended material.

Install with a compression tool to create a strong, permanent loop.

Keep ropes from slipping through pulleys and cleats or create a pull for overhead equipment.

Cut a sleeve to size, slip it over your rope, and shrink with a heat gun.

A lighter and more flexible alternative to wire rope lanyards.