We will reply to your message within an hour.
Adapt your USB port to connect to a variety of other devices.
Connect computers, monitors, printers, and other devices with DB connections.
Protect screw-together M12 connectors when not in use.
Protect harsh environment M12 connectors when not in use.
Assemble DB and HD connectors to replace worn out connectors.
Extend your cord’s life while stopping it from coming loose in places that are sanitized with water or steam as hot as 300° F, such as food plants and clean rooms.
Able to withstand temperatures up to 300° F, these grips are also corrosion- and chemical-resistant.
Wrap the split gland of these grips around ethernet cables with an RJ45 connector or other already installed cables for a water-resistant seal with your enclosure.
Because these grips resist absorbing water, they are less likely to crack or corrode than other types of plastics and metals.
These 90° elbows absorb less water and are less likely to crack or corrode than other types of plastics and metals.
Secure cords installed through enclosures and panels in wet environments while protecting them against sharp bends. With a flared end that keeps cords from bending without limiting too much motion, these grips extend cord life.
Vent air from your enclosure to equalize pressure and stop condensation from forming inside while securing cords in wet environments. These polyamide grips are lightweight and resist rusting.
A rubber bushing with an oval slot resists water and provides entry for building cable, which is also known as Romex type NM-B or type UF-B cable.
Tighten the screw-down clamp for superior pull-out resistance.
Made of PBT, these grips resist soaking up water in washdown and other wet environments while securing cords with an extra-strong hold.
Secure cords in washdown areas where there’s minimal space—these cord grips curve 90° to relieve stress from bending.
Suitable for use in applications where cords are underwater—these grips are rated IP68 for protection from prolonged submersion.
Keep cords from coming loose and seal water out of enclosures in extremely cold labs and storage areas. Thanks to their plastic bushing and rubber O-ring, these grips withstand temperatures as low as -75° F.
Secure cable installed through enclosures in wet environments while venting air to protect electronics from condensation.
These grips are the most corrosion resistant of any of our submersible metal cord grips.
These cord grips are lightweight yet durable.
Stainless steel construction offers the most corrosion-resistance of any of our multi-diameter wet-location cord grips.
These grips are nickel-plated brass for good corrosion resistance.
Modify these cord grips to get the right fit for your cord even when you don't know the exact diameter.
Attach a cord grip to cable without removing connectors and rewiring. These cord grips have a two-piece design to fit around cables with connectors.
The face of these grips is flush with the cable-entry point for a seamless appearance.
Adapt metric, NPT, and PG conduit and cord grip threads to match knockout threads.
Convert 10-pin cables to RS-232C for connection to PCs.
Hardwire these sockets to a power source.