These zinc-rich coatings offer the protection of hot-dip galvanizing to keep iron and steel free of rust and corrosion. They're designed for outdoor use, but can also be used indoors in well-ventilated areas.

Coatings with 99% zinc withstand temperatures up to 750° F.

Apply coatings in a can with a brush, roller, or sprayer.

Coatings that cannot be sold to Canada are restricted by product labeling requirements. Coatings that cannot be sold to the Los Angeles area, CA, CO, CT, DE, MD, NY, RI, and UT are restricted by VOC regulations.

These soft, pliable coatings add cushion and absorb shock. Use them to protect tools, dies, and other parts during shipping and storage. To apply, heat coatings and dip the object. Once removed, coatings can be melted again for repeat use.

Solvent-based coatings won’t dry out, even when stored over a long time.

Water-based coatings have no odor and won’t leave an oily residue once removed.

Pull off a small piece of putty and stick lightweight objects to your surface. It removes without leaving stains or residue on most surfaces and is reusable.

Temporarily stabilize objects on flat surfaces with this clear adhesive gel. It removes cleanly from most surfaces with a twist, and it won't dry out so it can be used again.

This putty-like glue cures into a pliable rubber. Use it to repair seals and cracks, or mold it into hooks and bumpers.

Bond sanding discs with a paper, cloth, or fiber backing to backup pads. This glue removes cleanly, so it's easy to change to another disc. It cannot be sold to the regions listed because it exceeds local regulatory limits on VOCs (volatile organic compounds).

These small tabs of pressure-sensitive adhesive offer convenient, no-mess bonding.

Rubber cement allows repositioning until fully dried. Use it on paper and cardboard.

Cement that cannot be sold to the regions listed exceeds local regulatory limits on VOC (volatile organic compounds).

Apply these adhesives on two surfaces, air dry, and then bring together to bond.

Adhesives that cannot be sold to the regions listed exceed local regulatory limits on VOCs (volatile organic compounds).

These adhesives resist temperatures up to 500° F, as well as chemicals, fuels, grease, and water. Apply them to both surfaces, air dry, and then bring together to bond. Heat to 300° F to reach full strength. They cannot be sold to the regions listed because these adhesives exceed local regulatory limits on VOCs (volatile organic compounds).