Direct your signal with these lights; they flash in one direction.

These lights cycle through three different flashing patterns.

Quickly position these portable flashing lights using the magnetic base to draw attention to hazards in areas such as docks and railroad crossings. They are battery operated, so they do not need to be wired or plugged in.

These lights can switch between being continuous or flashing.

These lights can switch between continuous, flashing, or revolving.

Small as hockey pucks, these lightweight strobe lights mount to surfaces and are unobtrusive when they’re turned off.

A series of four flashes per cycle makes these lights more visible than other strobe lights.

These strobe lights flash multiple times per cycle, making them easier to spot than standard strobe lights.

As small as a hockey puck and compatible with standard 12-volt vehicle plugs, these strobe lights are inconspicuous when not in use and quick to connect.

A series of four flashes per cycle makes these lights more visible than other strobe lights.

Set these portable lights wherever you need a signal light—they don't need to be wired or plugged in.

The buzzer warns workers of hazards even when they’re outside a direct line of sight.

Rated NEMA 4X and 13 for protection from dirt, washdowns, corrosion, and oil/coolant spraying.

These lights are rated IP69K to withstand high-pressure washdowns, such as those in food and beverage applications.

Mount the M22 male thread on the bottom of the light through a hole and then secure using the included nut.

Choose from seven colors, including nontraditional colors such as magenta and turquoise, for a custom four-light stack light.

Mount these lights horizontally or vertically in places where a tower will not fit.

Give a signal with the push of a button. These lights have a control box for activating each of the three light modules.

These lights emit three colors from a single lens and can be mounted in tight spaces where a tower will not fit.

Good for tight spaces where a tower of lights won't fit, these emit three colors from a single lens.

When motion is detected from both directions at a two-way corner, these lights flash to alert personnel and prevent collisions.

No need for wiring—these lights plug-in with a two-prong plug.

These lights are UL rated for use in hazardous locations where flammable/combustible gases, vapors, and liquids may be present.

These lights are sealed to protect against humidity, moisture, and dripping and splashing liquids.

These floodlights have heads that swivel and rotate for perfect positioning in hard-to-light areas.

Compact and easy to carry, these IP65-rated lights stand up to dust and low-pressure jets of water. The head adjusts up and down as well as side to side to direct light where it's needed.

A series of bulb heads are attached to a power cord to provide overhead lighting for job sites.

Keep excess cord out of the way—the reel locks the cord at any length and retracts it when not in use.

Use sun energy to bring light to remote areas and storage spaces without electrical wiring. These lights come with a solar panel to recharge their battery.

Bring light to areas that don't have electrical power service.

Because these lights are compatible with DeWalt rechargeable batteries, you can keep one type of cordless tool battery on hand. Their heads pivot to aim light where it's needed in areas that don't have electrical power service.

Also known as jelly jar lights. These fixtures have a guard that protects the lens from breaking.

Suspend or mount with fasteners to the ceiling.

Mount this light on a pole to illuminate pedestrian areas such as streets and walkways.

Heads adjust to any angle so you can direct light where needed.

These lights are UL listed for use in hazardous locations where flammable/combustible gases, vapors, and liquids may be present.

Hardwire these lights to a power source.

No need for wiring—these lights plug-in with a three-prong plug.

Plug in these rechargeable flashlights and they’ll automatically light up when the power goes out.

In addition to pivoting 210°, the light heads rotate 360° for directing light exactly where it’s needed. They're rated for use in environments where hazardous material is present.

Clip these little flashlights to any surface up to 1/2” thick and keep your hands free for work. They're rated for use in environments where hazardous material is present.

Safe for use in environments where hazardous material is present.

Gently bend these single-use lightsticks to activate.

Illuminate exits during power failures and other emergencies—these signs have battery-powered emergency lights. The backlit message meets UL 924 regulations for visibility.

These signs are rated NEMA 4X for corrosion resistance and washdown environments.

Mount these lights onto your vehicle.

Add these lights to a forklift to improve safety. They contain a turn light, brake light, and backup light.