Find misalignment across adjacent shafts—these clamps position a dial indicator on each shaft to locate offset or angular misalignment in both the horizontal and vertical axes.

This magnetic base has a threaded mounting hole to hold upright posts and fixtures.

The magnetic base has a V-grooved bottom for mounting on flat and curved metal surfaces and a magnetic release switch for easy setups. Use the fine-adjustment knob for precise positioning of the arm.

For more versatility than other low-profile holders, this holder has six locations for mounting indicators and accessories, including two mounting holes and four places to mount an indicator lug back with the included thumb screws. Use it in areas with limited space. The magnetic base has a V-grooved bottom for mounting on curved and flat metal surfaces.

The pins on these bases adjust to grip a variety of contours, such as sharp, rounded, and uneven surfaces. Use the threaded mounting hole to hold upright posts and fixtures.

The base is comprised of adjustable magnetic pins which allow it to conform to any shape and grip most metal surfaces. Use the fine-adjustment knob to precisely position the arm.

The threaded mounting holes on this base hold upright posts and fixtures. It has a flat bottom for mounting on flat metal surfaces and a V-step at the top of the base for mounting on round surfaces.

The magnetic base has a flat bottom for mounting on flat metal surfaces and a magnetic release switch for easy setups.

Create a stable base for your indicator on granite plates and other nonmagnetic surfaces. These bases have a threaded mounting hole to hold upright posts (sold separately) and fixtures.

Stabilize and precisely position your indicator with these weighted bases. Attached to the base, these holders have a jointed arm for moving your indicator up and down and in and out. Tighten the knob on the arm to lock it in place and use the fine-adjustment clamp for angling your indicator just right. Made of granite, the base has an extremely tight flatness tolerance, so it creates an accurate reference point for inspection work. It also means you can easily slide your workpiece in and out.

Vise-grip locking pliers clamp this holder to most thin, flat surfaces, and the flexible arm lets you position your indicator around obstructions. Lock the arm in place with a lever.

Use a swivel clamp (not included) to attach an indicator to the positioning arm. These holders are often used in areas with limited space. They have a magnetic base with a V-grooved bottom for mounting on curved and flat metal surfaces and a magnetic-release switch for easy setups.

Install a test indicator on each holding rod to check for shaft misalignment.

Position the arm by adjusting joints at the top, middle, and bottom. The magnetic base has a V-grooved bottom for mounting on curved and flat metal surfaces and a magnetic-release switch for easy setups. Holders have fine-adjustment knobs for precise positioning.

Set onto metal surfaces for a secure mount. Use the threaded mounting hole on these bases to hold upright posts and fixtures.