With extra-sharp abrasive, these rolls cut through hard metals. Trim off the length you need and stick it to your sanding tool. A slick coating on the abrasive prevents buildup and reduces heat. When it’s time to change the sheet, just peel it off and attach a new one.

Avoid clogging when wet sanding soft materials with these cut-to-length rolls. Their extra-sharp abrasive reduces heat that can cause material to build up. Rolls hold up to water, grease, chemicals, cutting fluids, and other solvents.

Everything you need to finish hard metals, even on curved surfaces and in hard-to-reach spots. The two abrasive sides are more rigid than on other sanding pads to cut through stainless steel and iron. Pads are cushioned with foam for controlled sanding pressure. They won’t deteriorate when wet-sanding with water or lubricants.

The extra-sharp abrasive cuts through hard metals faster than other discs. A hook-and-loop mount lets you switch grits and avoid the waste of adhesive-backed discs, which are done after one use. Pair with a compatible sanding tool or backup pad (sold separately).

Tackle hard materials with the combination of rigid abrasive and a flexible backing that conforms to curves and corners. These small pads fit tight spaces and are cushioned with foam for controlled sanding pressure. They have two abrasive sides and hold up to water and lubricants.

Pair these discs with a vacuum sander to keep your workspace clean. Dust is drawn away through the holes instead of floating into the air or building up on the abrasive. The hook-and-loop mount lets you switch grits without scrapping the disc, unlike adhesive-backed discs. Choose the hole configuration that matches your backup pad and vacuum sander.

The abrasive on these discs is sharp and durable enough to cut hard metals without dulling quickly. Press discs onto sanding tools or backup pads for a hold that won’t slip. To ensure the best bond, clean the pad with a mild alcohol—avoid harsh solvents such as MEK and acetone that can damage the adhesive. Also known as PSA discs.

Spend more time sanding and less time replacing clogged discs. A slick coating prevents dust and debris buildup on the abrasive surface. Press these discs onto sanding tools or backup pads for a hold that won’t slip. To ensure the best bond, clean the pad with a mild alcohol—avoid harsh solvents such as MEK and acetone that can damage the adhesive. Also known as PSA discs.

Create finer and more consistent finishes—these belts have a cushioned layer that creates more even sanding pressure on your workpiece. They also have a slick coating that prevents debris from accumulating on the abrasive surface and keeps operating temperatures low.

A sharp abrasive cuts through tough metals such as stainless steel, titanium, and iron. Trim these rolls for the length you need.

Switch from one grit to another without wasting discs. The hook-and-loop mount makes these discs reusable—unlike adhesive-back discs, which are one and done. Pair with a compatible sanding tool or backup pad.

Our most clog-resistant discs. These have a slick coating and a mesh backing to clear dust and prevent buildup that can dull the abrasive. The hook-and-loop mount lets you switch grits without waste, unlike adhesive-backed discs. Pair with a compatible backup pad and sander.

Sand complex shapes, corners, and edges with foam discs that conform to your workpiece. The open cell material holds liquid for seamless wet sanding. Discs are also washable, so give them a quick rinse if they clog. The hook-and-loop mount lets you switch grits without waste, unlike adhesive-backed discs. Pair discs with a compatible sanding tool or backup pad.