Turn your reciprocating saw into a high-powered scrubber. These brushes clean and prepare surfaces quicker than hand brushes, and with none of the effort. All have a _1/2'' universal shank that fits most reciprocating saws.

Make burr-free cuts in a variety of materials—from rubber to metal to stone. Made from a blend of silicon carbide and aluminum oxide abrasives, these cutoff wheels won’t clog or burn when slicing through nonmetals. They’re often used to cut hard or thick pipe, sheets, and bars to size.

Warning: Use wheels that have a greater rpm rating than the no-load rpm of your tool.

Slice through metal that’s hardened on the surface, such as linear motion shafts. The tips of the teeth on these blades tilt backward, so you can cut titanium, Inconel nickel, and other very hard metal too—they cut metals as hard as Rockwell C60. Also known as variable-set blades, their teeth vary in size, number per inch, and pattern to reduce vibration for a quiet, accurate cut. The blades are rigid, so they work best to make straight cuts. All have a welded seam and are ready to install on your band saw.

Made with boron nitride, second only in hardness to diamond, these wheels are highly wear resistant, so they easily cut steel with a Rockwell hardness of C50 or greater, including alloy steel, A2, D2, and T15 tool steel. While these wheels are not as hard as wheels made with diamond, they dissipate heat better.

Warning: Use wheels that have a greater rpm rating than the no-load rpm of your tool.

Made of ceramic alumina or a combination of ceramic alumina and zirconia alumina, these wheels last up to ten times longer than standard cutoff wheels when cutting hard metal such as Inconel nickel, Hastelloy nickel, and tool steel. Wheels are reinforced with two layers of fiberglass mesh.

Warning: Use wheels that have a greater rpm rating than the no-load rpm of your tool.

The combination of ceramic alumina and zirconia alumina in these wheels lasts up to ten times longer than aluminum oxide when cutting hard metal such as Inconel nickel, Hastelloy nickel, and tool steel. Wheels are reinforced with a layer of fiberglass mesh. Choose coarser grit for fast cuts; choose finer grit for smooth cuts.

Warning: Use wheels that have a greater rpm rating than the no-load rpm of your tool.

Made of ceramic alumina, these wheels last 10 times longer than standard cutoff wheels when cutting hard metal, such as tool steel. They’re reinforced with two layers of fiberglass mesh. These wheels, also known as Type 27, raised hub, and depressed-center cutoff wheels, outperform Type 1 wheels when making flush cuts.

Warning: Use wheels that have a greater rpm rating than the no-load rpm of your tool.