A coil makes a stronger grip than standard hairpin cotter pins to prevent accidental release.

Also known as safety pins, these are easy to install and remove. Tension keeps them closed.

Slide the pin through a hole then snap the ring down to lock these pins in place. Also known as click pins.

The double-head design lets you push or pull these pins from either side of the hole. Once in place there's little chance they will be vibrated out or knocked off.

For parts that spin or are otherwise difficult to access, slide these pins in and tap them with a hammer for a temporary hold. Reposition work, then bend the prongs outward to secure.

The wire retainer snaps closed to secure the pin for a one-piece alternative to a clevis and cotter pin combination. Also known as PTO pins.

Often used to connect equipment to a drawbar in towing applications, these rugged pins have a welded solid steel retainer.

Clip these pins onto grooved shafts and clevis pins to keep components in place.

Also known as split pins, these have one prong slightly longer than the other so they’re easy to open.

Lock by screwing the latch into the body.

A lock slides upward over the latch to lock. The latch opens outward to accept large diameters of rope.

A wide opening accepts large diameters of rope and pipe. Squeeze the trigger to release.

The narrow end restricts the movement of rope and chain, and the wide end allows room to attach multiple connectors.

Flat sides allow webbing and strapping to lay flat, so they won't slide and bunch.

These harnesses have leather-insulated metal components and meet ASTM F887 when used with an arc flash-resistant lanyard.

Made of heat-resistant Nomex, these harnesses withstand temperatures up to 700° F.

With D-rings on the shoulders, these harnesses allow you to raise and lower workers.

A quick-stop lanyard must be used when you have less than 18 1/2 ft. of fall clearance as it will stop your fall within a few inches.

Made of Kevlar, these lanyards meet ASTM F887 when used with an arc flash-resistant harness.

These lanyards form their own anchor point by attaching directly to a rated structure.