Filter by
System of Measurement
Pipe Size
Actuation
Valve Function
Voltage
Number of Ports
Thread Type
Maximum Actuator Temperature
Connects To
Valve Type
Connection Location
Body Material
Maximum Pressure @ Temperature
For Use Outdoors
Fitting Connection
Mounting Position
Actuation Time
DFARS Specialty Metals
Export Control Classification Number (ECCN)
REACH
Actuator Width
Duty Cycle
Electrical Connection Type
About Actuated On/Off Valves
More
Threaded Solenoid Diverting Valves
- For Use With: Air, Argon, Helium, Krypton, Neon, Oil, Water, Xenon
- Seal Material: Buna-N Rubber
These valves operate on electricity to automatically divert flow between ports. All can direct flow from the center-port inlet to either side-port outlet. Valves cannot shut off flow. They require a minimum pressure drop between the inlet and outlet for operation; the upstream pressure must be 10 psi greater than the downstream pressure. The actuator is directly mounted to the valve body to minimize movement and reduce wear.
Flow coefficient (Cv) is the amount of water (in gallons per minute) at 60° F that will flow through a fully open valve with a difference of 1 psi between the inlet and the outlet.
| Pipe Size  | Flow Pattern | Flow Coefficient (Cv) | Max. Pressure | Pressure Drop | Min. Pressure Drop Required | Temp. Range, °F | Actuation Time | Valve Lg. | O'all Ht. | Each | |
Brass Body with Wire Leads—120V AC | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
NPT Female × NPT Female × NPT Female | |||||||||||
| 3/8 | L-Pattern | 2.1 | 180 psi @ 165° F | Pressure Drop Assisted | 10 psi | 35° to 165° | 0 sec. | 3" | 4 7/8" | 0000000 | 0000000 |