These metal collars are stronger than plastic shaft collars.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

Use a wrench to rotate your drive shaft without marring or gouging the shaft.

Make quick adjustments to these shaft collars with a lever on the side.

These metal collars are stronger than plastic shaft collars.

Customize the bore of these collars to precisely fit your shaft.

Installing and removing a collar is as easy as pushing down and lifting up a clamp lever.

Formed to offset the weight of the clamping screw, these collars won't wobble or vibrate when shafts are spinning—even at high speeds.

Internal ball bearings allow you to slide a collar onto your shaft in one direction and then automatically lock the collar in place in the opposite direction.

An embedded sleeve squeezes the shaft as you tighten the clamping screws, allowing these collars to handle up to three times the thrust load of standard collars.

Offering the benefits of a two-piece collar in a one-piece design, these collars swing open for positioning then close anywhere on your shaft.

Mount these collars flush against each other or attach components to either side—the round body has flattened ends with tapped holes.

Two tapped holes on the face of these collars allow you to fasten them to gears, pulleys, and sprockets.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

To install, thread these one-piece collars onto the end of your shaft.

Install these two-piece collars square shafts.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Load material between the two halves of the ring and adjust the side bolts for a tighter fit than standard threaded-rod-mount clamping hangers.

Rubber cushions fit material tightly to reduce vibration and provide a more secure hold than loop hangers. The cushions also protect material from sharp edges and prevent corrosion caused by metal-to-metal contact.

For a more secure connection than rail- and adhesive-mount clamps, weld the bottom plate of these clamps onto your rails. They fit tightly around pressurized lines in hydraulic systems to lessen vibration.

A rubber cushion reduces vibration and wear from clamp edges. The cushion also protects lines of pipe, tubing, and conduit from corrosion caused by metal-to-metal contact.

For use with a single line, these clamps mount directly onto rails, no adhesive or welding required. They fit tightly around pressurized lines in hydraulic systems to lessen vibration.

Temporarily route material across duct, racks, machinery, and other ferrous surfaces. Clamps fit tightly around pressurized lines in hydraulic systems to lessen vibration. Rubber cushions reduce wear from clamp edges and protect lines from corrosion caused by metal-to-metal contact.

Often used in corrosive environments to support pipe passing through walls and floors, these collars are 303 stainless steel and sized specifically for a tight fit around pipe.

To avoid gouging and marring your pipe while making adjustments, these collars have flats where you can grab and rotate the pipe with a wrench. They're sized precisely for a tight fit around pipe, so they're often used to support pipe passing through floors and walls.

Mount these two-piece collars anywhere on an Acme lead screw without removing components.