Made of stainless steel, these springs are more corrosion resistant than steel springs. They're also easier to extend than steel springs. As you stretch an extension spring, it gets harder to pull. Minimum load is the amount of force required to start to extend the spring. Maximum load is the amount of force required to fully extend the spring. Rate is the amount of force required for every inch of extension or, for metric springs, millimeter of compression.

For technical drawings and 3-D models, click on a part number.

Also known as roll, tension, split, and expansion pins, these pins have a slot along one side that you squeeze closed to install them into unthreaded holes. Once installed, they expand slightly, creating outward tension that holds them tight against the hole wall. These pins absorb shock and vibration in your system, and keep parts from loosening. They are often used as hinge pins, or to hold springs and power transmission components in place.

Install these pins into a hole slightly smaller than the pin diameter. They have at least one chamfered end, which means the end is angled to make insertion easier.

Breaking strength is measured as double shear, which is the amount of force required to break a pin into three pieces.

Some metric pins with the same diameter come in two different wall thicknesses. Thinner walls are more flexible, easier to install, and won’t weigh down your assembly as much as thicker pins. Layer a pin with a thin wall inside a pin with a thicker wall to increase the breaking strength. Make sure the slots are opposite one another for maximum strength.

Steel pins are strong and wear resistant.

18-8 stainless steel pins offer a balance of strength and corrosion resistance.

Passivated pins offer added protection against corrosion and oxidation.

Pins that meet specifications for ISO 8752 (formerly DIN 1481) or ISO 13337 (formerly DIN 7346) adhere to international standards for pin dimensions.

For technical drawings and 3-D models, click on a part number.