Reduce vibration and prevent metal-to-metal corrosion on flat-bottomed objects such as strut channel and small duct.

Add a crossbeam for hanging lifting equipment, creating overhead conveyor systems, and supporting structural applications.

Attach these clamps to the flange of an beam, then hang a threaded rod from the threaded hole.

Also known as purlin clamps, these clamps are shaped to fit around beams that have a 45° or 90° lip.

For centered load distribution, these clamps grip both sides of the beam and hang threaded rod from the middle.

Support strut channel at a right angle to the beam.

Attach these light duty hangers to beams and other structural elements. They include a stiff wire for supporting ceilings, lighting fixtures, and other lightweight material.

Turn the handle to tighten these multipurpose tools for strong clamping in nearly any application.

With five times the capacity of standard C-clamps, these are the highest capacity clamps we offer.

All components of these clamps are made of aluminum-bronze that is Factory Mutual approved. They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Plastic clamping surfaces prevent damage to material.

Made entirely of fiberglass, these clamps won’t transmit electricity and are chemical resistant. They're often used around electrical equipment as well as in plating and anodizing applications.

Three screws apply pressure to three sides of a workpiece.

Hold the workpiece down against a bench or table.

The jaws move in unison to apply even pressure and prevent twisting.

Fit the draw arm over a latch plate and pull the handle to clamp.

Mount the clamp on a lid and the latch plate on the side of a container.

A removable, heavy duty steel base plate provides a flat, durable clamping surface. Carry it where needed or mount the base plate to your workbench.

Angled jaws clamp sheets, bars, and U-channels at 90°.

The jaws on these tools apply outward pressure for use as a spreader.

Squeeze the handles and the jaws will automatically adjust to fit your workpiece.

Use in pairs with a two-leg sling to transfer metal plates in a horizontal position. Unlike other plate-lifting clamps, these can pick up multiple plates at the same time.

Pads on these clamps prevent the grip from biting into the load.

Lift metal plates by hand by gripping the edge.