These coupling nuts have good chemical resistance.

More corrosion resistant than 18-8 stainless steel coupling nuts, these nuts have excellent resistance to chemicals and salt water.

Stainless steel coupling nuts have excellent corrosion resistance in most environments.

Mount components onto food processing lines, walls, and sanitary equipment while leaving space to clean in between.

These standoffs are designed to fit in the limited space of compact electronics such as laptops and hand-held devices.

Once the end is clinched in place, panels with keyholes easily slide on and off these supports.

Connect two differently sized male-threaded parts, such as threaded rods, and tighten with a standard wrench.

Increase or decrease metric thread size from one male-threaded part to another. Commonly used to connect two differently sized threaded rods, they have a hex-shaped body, so you can tighten them with a standard wrench.

Change thread sizes or types, such as fine to coarse threads, on parts without changing gender.

Change inch threads to metric with these adapters, or swap metric threads for inch. An external hex lets you tighten or loosen them with a wrench.

The through hole allows you to connect float rods to float valves.

Need to join two female-threaded parts, such as coupling nuts, with dissimilar inch thread sizes? Attach them to these adapters and tighten the exterior hex nut for a secure connection.

One side inch, one side metric, and a hex in the middle—these handy fasteners connect two female-threaded parts, such as coupling nuts, adapting from inch threads to metric. Tighten with a standard wrench.

Similar to turnbuckles, these rods have right-hand threads on one end and left-hand threads on the other so you can make a linkage that adjusts for tension.

Designed for use with right-hand, externally threaded rod ends, these rods have right-hand threads on both ends. Use them for remote valve operators, throttle controllers, shifting mechanisms, and virtually any push/pull assembly.

Made of stainless steel for excellent corrosion resistance, these nuts make pivoting and hinge movements where misalignment is not a concern.

Pair these nuts with vibration-resistant compression sleeves and fittings for a strong seal on stainless steel tubing.

Also known as CGA nuts, these are designed for low-pressure welding applications downstream of your pressure regulator. Attach them to barbed hose fittings for compressed gas to make a threaded connection to torches or pressure regulators.