From cookware to chemical-processing equipment, 304 stainless steel is a good all-around choice for a wide range of applications.

When compared to standard 304 stainless steel, this material can be machined faster with less wear on cutting tools. It's also called Prodec and Project 70+.

This wire bounces back after bending. It’s often used to construct springs and wire rope.

The textured surface hides fingerprints and dents. This material is widely used in decorative applications, such as partitions and handrails.

This material has tighter tolerances than standard 303 stainless steel.

The addition of molybdenum gives 316 stainless steel excellent corrosion resistance. Use it in a variety of marine and chemical-processing applications.

This material machines faster with less wear on cutting tools than standard 316 stainless steel. It's also called Prodec and Project 70+.

These rods have been passivated for enhanced corrosion resistance.

2205 stainless steel resists cracking even when faced with a combination of tensile stress, corrosive chemicals, and heat. Also known as duplex stainless steel, it has twice the strength of 316 stainless steel. Use it for high-pressure applications in caustic environments.

With a diameter that’s held to a close tolerance, this material is hardened for increased wear and abrasion resistance.

Ready for turning in your lathe, these rods are precision ground to a tight tolerance.

Often used for fasteners and valves, 410 stainless steel withstands wear caused by abrasion.

One of the most machinable types of stainless steel available, 416 contains sulfur for fast machining without clogging cutting tools. It's used for gears, screws, and shafts.

Precision ground to a tight diameter tolerance, these rods are all set for turning applications in a lathe.

With a higher chromium content than 15-5 PH stainless steel, this high-strength 17-4 PH offers better corrosion resistance. It is also known as 630 stainless steel.

Each piece is precision ground to offer tighter tolerances than standard 17-4 PH stainless steel.

Also known as Project 70+, this material machines faster with less wear on cutting tools than standard 17-4 PH stainless steel.

Widely used to fabricate fasteners and engine components, A286 will maintain its strength as temperatures rise.