Store tools such as brooms, screwdrivers, and flashlights with these holders that attach to magnetic surfaces.

Keep instructions and safety sheets on any magnetic surface, such as a steel cabinet, desk, or machine.

These holders keep steel tools and knives in place magentically.

Hold steel tools, nails, nuts, screws, and other magnetic items on your pegboard.

Keep nails, nuts, screws, and other easily lost magnetic items on hand.

The base is comprised of adjustable magnetic pins which allow it to conform to any shape and grip most metal surfaces.

Use this holder in areas with limited space. It has a nut and bolt for holding a 1/4” lug-back indicator.

These Mitutoyo indicators have a magnetic base with V-grooved bottom to provide a solid mount on flat and curved metal surfaces. They also have a magnetic release switch for easy setups.

For a solid mount on metal surfaces, these indicators come with a magnetic base. They have a continuous dial numbered clockwise around the face for direct measurements. A spring-loaded plunger retracts and extends to measure objects.

Temporarily mount routing rings and other threaded components to steel and iron surfaces.

Two clamps connected by a pivoting arm hold workpieces at nearly any angle.

Sized for small parts and tight spaces, these clamps have a pivoting pad at each end to hold workpieces at any angle up to 180°.

Switch the magnets on these clamps on and off for easy placement and removal of your workpiece.

Use hex-shank bits (also known as insert bits) in powered tools.

Keep bits from slipping. Insert a bit into the adapter, place a screw on the end of the bit, and slide the adapter sleeve over the screw. The sleeve retracts as the screw is driven. These adapters hold hex-shank bits (also known as insert bits) in powered tools.

Bend these adapters up to 90° to access hard-to-reach fasteners. Use them to hold hex-shank bits (also known as insert bits) in powered tools.

Insert these adapters into your SDS-drive rotary hammer to use it with hex-shank bits (also known as insert bits).

Eliminate the need for multiple bulky tools with these bit adapters. At less than 3 inches long, these compact adapters convert ¼” bit screwdriver handles and ¼” bits into torque screwdrivers so you can fasten to a specific torque.

Use a 4 mm bit in a bit driver that's designed for 1/4" bits.

The toughest bits available, these withstand the shock and twisting force of impact drivers. A magnet holds the nut in place.

Because they make contact on the flat sides of fasteners rather than only on the corners, these magnetic bits significantly reduce slipping and stripping. They’re also known as lobular bits.

An insulated handle and shaft protect against shock from accidental contact with live electrical circuits. These tools are tested to 1,000 volts to meet EN 60900 and IEC 60900.

Operate these tools like a standard bit driver and access hard-reach fasteners with the offset head. Insert a bit and a magnet holds it in place.

A ratchet mechanism allows you to drive fasteners when there's little space to move the handle.

Mount to walls, cabinets, and other steel surfaces.

Organize your tool drawer by positioning these low-profile rails to accommodate wrenches of any length.

These holders mount to steel surfaces and are easy to reposition.

A magnet holds the door open; pull on the door to release.