Ratcheting action gives these tools greater leverage than standard tube benders for bending thick-wall material.

Bend more than one size of tubing without adjusting the bending head.

Bender with 1" bend radius—Copper must be annealed before bending.

These tools include one slide bar and 10 bending mandrels for 1/4" to 5/8" tube OD. The hand crank provides precise bends with low effort. They can be mounted to your bench top or clamped in a vise. A pedestal and tooling rack are also included.

Ratcheting action provides fast, low-effort bending. Bender can be bench-mounted with the included fasteners. Bending mandrels for 1/2" to 2" tube OD are sold separately.

Make bends in up to 135° in fuel, brake, and hydraulic lines. This bender can be clamped in a vise.

Use one hand to make bends up to 90° in soft metal tubing.

Use the same bender for many different conduit and pipe sizes. These benders have ratcheting action to eliminate repositioning of the conduit or pipe when making multiple bends.

Powerful enough to bend conduit and pipe to the angle you need, this bender is for use on Schedule 40 pipe.

Make on-the-fly bends in Schedule 40 PVC conduit and pipe without the risk of kinks or cracks. Lightweight and flexible, these benders are easy to keep on hand for occasional use and last-minute adjustments. Insert them into your conduit or pipe and bend across your knee. They do not require heating or access to a power source; however, they're not as precise as traditional benders and only work with a single pipe size.

Heat PVC conduit and pipe, then manually bend it to your desired angle. This electric blanket wraps around your workpiece and secures with a hook-and-loop strap.

Follow the easy-to-read markings to bend conduit to the angle you need.

Aluminum heads are lighter than cast iron heads.

Handles are labeled with a bending guide.

Create smooth, accurate bends in round heat pipe for routing heat away from sensitive electronic components and toward a heat sink. These specially designed tools allow a smooth bending motion to reduce marks on your pipe, which ordinary pliers can often leave behind. All have graduation markings to prevent over bending, which can reduce the ability of your heat pipe to transfer heat. Every 45° bend in a heat pipe will reduce the cooling capacity of the heat pipe by about 2.5%. Place these tools on benches, vises, and workstations without scratching them—all have rubber mounting feet.

Bend wire and rod up to 3/8" diameter and flat stock up to 1/2"×3/16" to create hooks, brackets, and pipe hangers. They can be clamped in a vise.

Create squares, coils, and S-shapes. This bender can be mounted to your bench top or clamped in a vise. Circle pins make additional sizes of bends and coils.