Make a custom panel light with your choice of light and lens cap color.

Lights have a watertight O-ring seal.

The pad below the base absorbs shock and vibration.

Direct your signal with these lights; they flash in one direction.

Quickly position these portable flashing lights using the magnetic base to draw attention to hazards in areas such as docks and railroad crossings. They are battery operated, so they do not need to be wired or plugged in.

Place these lights in full sun and their batteries charge during daylight hours. Lights automatically switch on at dusk and off at dawn.

Small as hockey pucks, these lightweight strobe lights mount to surfaces and are unobtrusive when they’re turned off.

Easier to spot than other strobe lights, these lights emit bursts of multiple flashes.

A series of four flashes per cycle makes these lights more visible than other strobe lights.

As small as a hockey puck and compatible with standard 12-volt vehicle plugs, these strobe lights are inconspicuous when not in use and quick to connect.

Mounted on a tripod, these lights stand higher for greater visibility than other strobe lights.

These strobe lights flash multiple times per cycle, making them easier to spot than standard strobe lights.

Carry these lights around with you and place them wherever needed. They can switch between being continuous or flashing.

These lights can switch between continuous, flashing, or revolving.

The buzzer warns workers of hazards even when they’re outside a direct line of sight.

The revolving motion of the light makes these more visible than flashing lights.

These lights have lenses that snap in and out, so you can easily swap colors or change their position in the stack.

Design a stack light with your choice of light pattern and color. Start with a base, then add up to five modules total—twist and lock them together.

Use these lights in tight spaces in place of a tower. They emit three colors from a single lens.

The quick-connect four-pole M12 plug on these lights makes them easy to hook up and configure.

These lights have LED bulbs for years of maintenance-free operation and can be wired as either continuous or flashing.

Get notified about equipment issues even when you aren't around your machines. These lights connect to your computer via Ethernet, allowing you to set up email alerts when there is a problem with a machine, server, or conveyor.

Direct traffic with these colored lights.

Use these as replacement bulbs in stack lights.

Just like traditional tubular lights that illuminate your machine with a bright white light, these lights can also be programmed to switch over to a red or green light for communicating machine status.