This metal strapping is the standard for packaging and shipping applications.

Roll these dispensers wherever you need them.

Keep this banding on hand for both permanent connections and emergency repairs. You'll need an installation tool and a buckle (both sold separately) to create a band clamp.

These clamps are easier to install than our Extra-Strength Low-Profile Band Clamps. Also known as center-punch clamps, they seal with a quick hammer blow to the buckle.

One clamp fits a wide range of diameters, so you can always have the right size on hand.

These clamps are easier to install than worm-drive clamps—crimp the pinch points with pinch-clamp pincers for a secure hold. They are also known as ear clamps.

Not as bulky as our other constant-tension clamps, these round-wire clamps easily fit in cramped spaces. Use in low-pressure applications.

Clamps come packed in a box with individual compartments for each clamp size. To make sure they won’t cut into hose and tube, they have a smooth band with rolled edges.

Unlike other duct hose clamps, these are rated for a maximum work load. Clamps have a quick-release latch that lets you access your line frequently while maintaining your original clamp size.

Mount to a surface and add a cable tie to secure a bundle.

Tighten cable ties and trim the excess with these tools.

These ties have a loop on each end that can be twisted around each other for a secure closure.

Permanently sew webbing onto these buckles.

Attach webbing to these buckles without sewing.

Use the split in the hook to slide a loop on and off these fittings.

Add a slide to webbing to make adjustable straps.

Attach these hooks to elastic cord to make a tie down.

The thick wire coil on these hooks makes them stronger than standard hooks.

Sew webbing onto these plates for a permanent anchor point or run webbing through to use them as guides.

For applications requiring high heat over long periods of time, these aluminized steel heaters warm up faster and are more durable than silicone rubber heaters.

Also known as seizing bands, these prevent fraying while cutting wire rope. Wrap the band around the wire rope and squeeze the flat end into the indented end.

Mount a sign to a 4" to 12" diameter post or column.