Choose the ID, OD, and length you need.

Also known as jig bushings, these metric drill bushings fit inside fixture plate holes to guide drill bits, counterbores, reamers, and other cutting tools. They improve accuracy so that your drilled holes and cuts are consistent from part to part.

The head prevents these bushings from being pushed through the jig when drilling pressure is extreme. The head sits above the jig plate or can be mounted flush by installing in a counterbored hole.

Even under extreme drilling pressure, these metric bushings won't press through your jig plate. A flanged head on the top of the bushing acts as a stop, preventing it from moving as you push down your drill bit, reamer, or other cutting bit.

Choose the ID, OD, and length you need.

The knurls resist force and provide better holding strength than serrations. Encase in plastic tooling.

Insert these bushings into a drilled hole and twist the lock ring to secure. Reusable and easy to replace, they are held in in place by a separate locking part.

With their mirror-like finish, these are the go-to spacers when appearance matters.

Also known as arbor spacers, these are notched to space components on a keyed shaft.

Be prepared with ring shims in a variety of thicknesses. These shims fit around fasteners and shafts to precisely align, level, and adjust spacing.

For a snug fit around a shaft, the ID of these shims is held to a tighter tolerance than other round shims.

Be prepared with shims in a variety of thicknesses. These shims are shaped to fit over D-profile shafts. Use them to precisely align, level, and adjust spacing.

Spin these shims onto screw threads to extend the shoulder length.

Be prepared with shims in a variety of thicknesses. Also known as arbor spacers, these shims are notched to fit over keyed shafts.

A zinc-plated finish gives these steel inserts mild corrosion resistance.

Ridges on the barrel of these inserts make them less likely to split hardwood than inserts with prongs. They're often used in wood that has been cut across the growth rings.

Steel inserts have high strength for durability.

Use where vibration is a concern—these tee nut inserts have distorted threads that lock screws in place.

Steel inserts have high strength for durability.

The strongest key-locking inserts we offer, these inserts are made to stringent military specifications.

A closed-end tap, drill bit, and installation bit are included with these inserts.

The knurled body holds these inserts in place in aluminum and other soft metals. Use an arbor press to install them in untapped holes.

Adhesive on both the internal and external threads keeps these inserts in place and holds screws tight.

Use round shims to precisely align, level, and adjust spacing on shafts and machinery.

Place these shims under sharpened dies to restore their original height and extend the life of the dies.

Use ball bearings in debris-free environments and when speed is a necessity. They operate with less friction than sleeve bearings, so you can run them at higher speeds.

Engineered for simultaneous linear and rotary motion, these bearings are used with round end-supported shafts.

The choice for low-friction motion in high-temperature environments.

The flanged housing makes these bearings a good solution for vertical linear motion applications.

A flanged housing with mounting holes connects these bearings directly to your system. They have a grooved inner diameter that's designed to work with spline shafts. Together, they transmit rotary power while allowing the bearing to move freely along the length of the shaft.

With a flexible layer of neoprene sandwiched between an oil-embedded bronze bearing and rigid steel shell, these bearings reduce wear and machinery noise.

The galvanized finish on these fittings provides fair corrosion resistance. Fittings are for use in low-pressure applications.

These fittings can stand up to high-pressure applications. Use them in noncorrosive environments.