Use these sets to knock out pins and rivets that have already been loosened.

The rounded tip of these punches fits into the open ends of hollow and spring pins to protect them from damage during removal.

Contains pin-loosening, pin-removal, and center-marking punches as well as chisels.

Attach two punch heads to the handle at the same time to punch a gasket or washer in a single strike.

Quickly switch between inner and outer punches to create washers faster than with standard sets.

Slide thin sheets of material into the included die block then punch an inner and outer hole to create a shim or washer.

The driver supplies eight tons of force to the hole punches in this set to make straight punches.

Create larger holes and make repeated punches with these drivers that supply 11 tons of force to the included hole punches.

A locking clamp eliminates the need to thread the punch onto the stud, making setup and disassembly quicker than with standard punches.

Fit the punches in these sets through existing holes and mark the center of the hole in a second workpiece.

Also known as blind-hole spotters, the punches in these sets fit into closed-end holes and mark the center of a complementary hole.

The punches in these sets have a uniform shoulder height so you can quickly transfer multiple hole locations at once. Also known as transfer screws.

Also known as center punches, the tools in these sets mark hole centers in metal and other materials.