System of Measurement
    System of Measurement
    Metric
    Inch
    Pipe
    Chamfer Type
    Chamfer Type
    Plug
    Bottoming
    Thread Direction
    Thread Direction
    click to learn more about
    click to learn more about Right Hand
    click to learn more about Left Hand
    Right HandLeft Hand
    Thread Type
    Thread Type
    click to learn more about
    Metric
    For Insert Thread Type
    For Insert Thread Type
    UNC
    Metric
    UNF
    NPT
    UN8
    BSPP
    Pitch Diameter Limit
    Pitch Diameter Limit
    default
    H2
    H3
    H1
    H4
    H5
    D9
    D8
    H6
    Not Rated
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Number of Flutes
    Number of Flutes
    3
    4
    5
    6
    For Minimum Material Thickness
    For Minimum
    Material Thickness
    Less than
    0.5"
    0.5" to 0.74"
    0.75" to 0.99"
    1" to 1.49"
    1.5" or
    greater
    3.8mm
    Number of Inserts Included
    Number of Inserts Included
    2
    4
    5
    6
    10
    12
    For Maximum Hole Diameter
    For Maximum Hole Diameter
    Less than 0.5"
    0.5" to 0.74"
    0.75" to 0.99"
    1" to 1.24"
    1.25" or greater
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    195 Products