This welded, one-piece strut channel combines two strut channels back-to-back.

Up to two times the height of regular strut channel, this high-profile channel is stronger than regular strut channel.

Slide the strut channel into the tube for telescoping length adjustments.

For compatibility with quick-connect clamps to secure pipe and conduit without screws and tools, this strut channel has narrow slotted holes.

Designed to wrap around the sides of strut channel, these brackets provide a stronger hold than other strut channel brackets.

These brackets have narrow slots compatible with quick-connect clamps for securing pipe and conduit on the channel side of struts without screws or tools.

Serrated grooves grip the lip of the channel.

Connect two channels to create a stacked channel.

There's no need for additional fasteners with these nuts—they combine a strut channel nut with a spring and a threaded stud.

Push these nuts into place rather than threading them onto a fastener.

A tab fits tightly against the lip of the channel to keep these nuts from slipping.

Use with hex nuts to connect threaded rod.

Notches on these washers grip the channel to keep them in place.

Securely fasten strut channel to the floor.

Mount a length of strut channel between the ends of a beam to run cable and conduit along the beam without drilling.

Brackets mount on the outside of strut channel to allow trolley movement.

Support the corners of strut channel structures.

Create a four-sided raceway for cable, or give a more finished look to strut channel structures.

For quick mounting of components, these hangers snap into strut channels for a strong hold and easy repositioning.

Provide smooth motion between two pieces of strut channel.

Route pipe, tubing, and conduit across strut channel.

Secure insulated pipe to strut channel without pinching the insulation or exposing the pipe. These clamps are sized for use with insulated pipe and have a plastic insert that creates a seal around the insulation to prevent the pipe from sweating, which can cause mold and corrosion.

For areas with low clearance, these clamps have the mounting fastener to the side of the material, rather than on top.

Slide these clamps into strut channel and snap closed for quick installation with no tools required. They are noncorrosive, nonconductive nylon.

Reduce noise caused by HVAC systems. These sturdy rubber supports isolate vibration caused by heat pumps and air conditioning units, resulting in a quieter facility. When used on roofs, they also keep components above puddled water, which can cause damage.

These plastic hangers prevent corrosion caused by metal-to-metal contact. Push them closed for a more secure hold on material than loop hangers.