These brackets have greater weight capacities than standard duty fold-away shelf brackets.

These standards and shelf brackets are more stable and hold heavier loads than single-slotted standards and brackets.

Design a complete shelving unit with these standards, shelf brackets, and metal shelves. All components are corrosion resistant and are often used for quality control, laboratory, and food service applications.

Commonly used on hood and trunk lids, these simple, three-piece rods telescope from 18 1/2" to 46 3/4" to prop lids open at a variety of angles.

Keep environments free of contaminants—with plastic bushings, there's no metal-to-metal contact that can release particles as these supports open and close. Manually control these free-moving lid supports through their full range of motion. Raise the lid until the hold-open mechanism on the support is engaged; slightly lift it again to release the hold and close the lid.

Manually control these standard free-moving lid supports through their full range of motion. Raise or lower the lid until the hold-open mechanism on the support is engaged; slightly lift it again to release the hold and close the lid.

No separate hinges are required, these supports act as a hinge and lid support all in one. Springs provide lifting assistance to raise and hold lids open—slightly lift the lid to get it started and the support will do the rest. Manually shut the lids and the supports will hold them in the closed position.

Gradually slow your lid's motion to prevent it from slamming open. To open lids, lower them and the support will slowly and softly do the rest. Manually shut the lids and the supports will hold them in the closed position.

For a secure hold on pipe and conduit suspended above the ground, these supports have a cushioned clamp provides a 360° grip while reducing vibration.

Adjust supports to the exact height you need to route pipe, conduit, and tubing through strut-mount routing clamps and hangers.

Reduce noise caused by HVAC systems. These sturdy rubber supports isolate vibration caused by heat pumps and air conditioning units, resulting in a quieter facility. When used on roofs, they also keep components above puddled water, which can cause damage.

Mount these brackets between two studs to support copper tubing for sink faucets and other water supply fixtures.

Clip these saddles around the outside of strut channel for a quick way to route insulated tubing and pipe. Lips on either end of the saddle protect insulation from abrasion if the pipe should move.

Support vertical pipes passing through floors.

The screw adjustment allows you to make small changes to the height of your load.

Limit wrist movement and maintain a safe, neutral position.

Prevent tennis elbow injuries caused by straining forearm muscles.

Stabilize sore and injured knees to relieve pain and promote healing.

Protect elbows from bumps and scratches.

Add legs to these brackets and mount to a tabletop to create a folding table.