Close off unused switches.

Add depth to your switch box.

Knockouts allow you to modify these boxes to fit your application.

These boxes come ready to use with receptacles and/or light switches installed.

Knockouts allow you to modify these boxes to fit your application.

Close off unused outlets.

Add depth to octagonal outlet boxes.

Mount these boxes to the outside of an enclosure to access a programmable logic controller or other networked device without opening the enclosure.

Use the built-in connections to attach conduit without using fittings.

These boxes have an open back to accommodate extra-deep low-voltage devices.

Mount these boxes on the surface of your wall in areas where you can't create a recess.

Build your own outlet box or replace a damaged box.

Keep the cover closed during operation to completely shield the outlet and plug from rain, snow, and wet conditions.

Close off unused outlets.

Close off unused outlets.

These corrosion-resistant boxes are built to withstand exposure to rain, snow, and wet conditions.

Close off unused switches and outlets.

Close off unused switches and outlets.

Snap end and center sections together to create your own two-device or wider wall plate.

Cover existing outlets and switches for a refreshed appearance, no rewiring necessary.

Protect toggle switches from moisture and dust by replacing panel mounting nuts with these rubber covers.

A nickel-plated brass cap protects toggles from impact.

Seal the panel cutout around a toggle switch.

These rubber covers protect switches from splashing liquid.

Choose an actuator and contact block to make your own 30 mm switch.

It takes two hands to activate these switches, minimizing the risk of accidental equipment start up.

Lock out the on/off or emergency-stop buttons on machinery to prevent accidental or unauthorized startups, such as during maintenance.

Suitable for most major multipole breakers that have a tie bar, including GE, ITE, Sylvania, Challenger, Bryant, Westinghouse, Square D, and General Switch Co.

Secure a single breaker switch with multiple padlocks, so electricity stays safely off until everyone's done working.

Use the push-button end to easily install these lockouts on circuit breakers with pin lockout holes on the inside of the circuit-breaker toggle switch that are mounted on DIN rails.

Sets include a variety of electrical and valve lockouts as well as padlocks.

An alarm sounds when the cover is lifted.

Reduce the spread of illness by keeping the surface of buttons, such as those in an elevator, free of bacteria and germs.

For use with washdown receptacles, these outlet boxes withstand corrosive and washdown environments.