The strongest of the potting compounds, epoxies are rigid and wear resistant. They have excellent chemical and moisture resistance, withstand a wide range of temperatures, and provide excellent electrical insulation.

A high silver content allows these surface fillers to conduct electricity and heat. Use them to fill gaps and rebuild missing material on electrical connections or to assemble new components.

Quickly conduct heat away from electronic components. Kapton® polyimide gives this tape excellent electrical isolation.

Made with fiberglass for durability and abrasion resistance, this tape also withstands high temperatures.

PEEK offers the best wear and abrasion resistance of our low-friction tapes. Use it for wire wraps and sliding bearing surfaces.

Fiberglass is laminated with Teflon® PTFE for a slippery, durable tape with excellent chemical and temperature resistance. Use it as a release surface on heat sealers and blister forming equipment.

Often referred to as Rulon and bearing tape, this self-lubricating PTFE tape provides better abrasion and wear resistance than our standard slippery PTFE tape.

In addition to handling temperatures up to 500° F, this fiberglass tape is tough enough for abrasive applications such as sand blasting.

At half the thickness of our other masking tape for electronics, this polyimide tape conforms easily to components.

Often used to repair vinyl facings, this tape can be used on water heater blankets and fiberglass insulation joints.

Seal fiberglass duct and insulation that's faced with an all-service jacket (ASJ). Tape is reinforced with fiberglass.

To simultaneously mix and dispense two-part adhesives, attach these mixer nozzles to a dual cartridge.