These hangers fit a range of material sizes. Push them closed to lock at the size you need. They provide a more secure hold on material than loop hangers.

Clip these hangers onto the side of threaded rod. Unlike other threaded-rod-mount hangers, you can use more than one hanger on the same rod to organize multiple lines of pipe, tubing, and conduit.

Mount these hangers on top of one another to organize multiple lines of pipe, tubing, and conduit at any angle.

Rubber cushions fit material tightly to reduce vibration and provide a more secure hold than loop hangers. The cushions also protect material from sharp edges and prevent corrosion caused by metal-to-metal contact.

Connect these hangers to organize multiple lines of pipe, tubing, and conduit. The tight-fitting, santoprene body reduces vibration and prevents corrosion caused by metal-to-metal contact.

Use these hangers in corrosive environments and where chemicals are present. They're also known as teardrop hangers. Combine with a threaded rod or other fastener to hang from the ceiling.

A roller on the bottom of these hangers compensates for movement due to expansion and contraction, such as in hydraulic applications. Combine with a threaded rod or other fastener to hang from the ceiling.

Route multiple lines of pipe, tubing, and conduit with a single hanger. A wide opening and locking tab allow access for installation, adjustment, and removal.

Mount these general purpose U-bolts into an existing bracket, or combine with a mounting plate for a secure hold at the mounting surface.

Suspend and route flat-bottomed objects such as strut channel and small duct.

Also known as muffler clamps, these U-bolts have a rounded mounting plate that fully surrounds pipe, conduit, and tubing for a secure fit.

These fiberglass-reinforced polyurethane U-bolts have no metal parts, so they won't conduct electricity or cause metal-to-metal corrosion.

Attach these clamps to the flange of an beam, then hang a threaded rod from the threaded hole.

These clamps rotate 360° and pivot 45° to ensure the rod hangs straight, even on sloped beams.

For centered load distribution, these clamps grip both sides of the beam and hang threaded rod from the middle.

A secure way to hang threaded rod from a pair of angles, such as those used in ceiling joists, without the need to drill or weld. These clamps are commonly used to suspend HVAC, conveyor, and other overhead systems.

Also known as bridle rings, routing rings have an open-eye design that allows you to quickly install wire and cable.

Fasten these brackets to ceilings, walls, beams, and joists to hang threaded rod.