Reduce the chance of getting pinched when unclamping. These clamps have more space between the handle and the arm than other low-profile toggle clamps.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Mount these clamps to a bench top or other surface to keep workpieces in place.

Push the lever to lock the handle and prevent accidental opening.

Push the lever to lock the handle and prevent accidental opening.

Weld these clamps to the side of an object or drill your own holes in the mounting plate and bolt into place.

The mounting base secures these clamps to a rail or bar.

Mount these clamps below a surface.

These clamps have mounting holes on the bottom.

Suitable for production applications, these clamps have double the service life of other air-powered toggle clamps.

The base fits into round or square holes on most workholding tables for clamping anywhere on the work surface.

Smaller than standard push/pull toggle clamps, these are often used for electronics and small fixturing applications.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Smaller than standard push toggle clamps, these are often used for electronics and small fixturing applications.

Moving parts are protected by a metal cover when the clamp is engaged to prevent dirt and dust from clogging the clamp.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

Secure these clamps to a rail or bar.

Drill a hole to mount these clamps through a surface and secure the mounting flange with screws. The plunger can be locked at any position along its travel.

Push the lever to lock the handle and prevent accidental opening.

Mount the clamp on a lid and the latch plate on the side of a container.

For repetitive clamping, turn the holding screw to adjust the opening size one time, and then use the handle to secure and release workpieces.

Screw these clamps directly into a tapped hole in a fixture.