Also known as paddle latches, these are often used on electrical panels, cabinets, and lockers.

A plastic-coated handle and hook prevents the release of particles from metal-to-metal contact, which makes these latches good for clean room applications.

Designed with compression springs to withstand vibration better than standard draw latches, these offer a more secure hold.

These latches are typically used to secure hoods and covers.

An integrated slide bolt extends into the strike plate to resist pull and vibration from side-to-side, front-to-back, and up-and-down forces.

No need for a strike plate, these latches hook into a lip or notch.

These latches hook into a lip or notch and have an adjustable latching distance to compensate for gasketing and misalignment.

To prevent accidental opening, these latches have a safety catch.

Adjust the latching distance for a tight fit over gasketing and to compensate for misalignment.

Draw lightweight surfaces together with these latches.

With a spring-loaded handle, these hold tighter than other turn-to-open draw latches and compensate for slight misalignment.

For use on gasketed doors, these latches use downward compression to pull surfaces together. They have a safety catch to prevent accidental opening.

Mount these latches on a corner to draw perpendicular surfaces together. They have a safety catch to prevent accidental opening.

Each latch comes with a variety of strike plates for different mounting options.

No need for a strike plate, these latches hook into a lip or notch.

Open several draw locks with the same key.

Designed for use in 1/2" dia. through holes.

Use these locks in a 3/4" dia. through hole, which is the most common through-hole size.

Made of plastic, these locks are suitable for damp and humid environments.

These highly pick-resistant locks have specially designed half-moon keys that cannot be duplicated.

A stainless steel shutter blocks rain, snow, and dirt from entering the cylinder where they can cause internal damage.

Also known as compression cam locks, turn the handle a quarter-turn to latch, then another quarter-turn to draw the cam firmly against the door or drawer surface.

Use these locks in a 3/4" dia. through hole, which is the most common through-hole size.

Made of plastic, these locks are suitable for damp and humid environments.

To prevent internal damage, these locks have a stainless steel shutter that blocks rain, snow, and dirt from entering the cylinder.

These sets come with four cam locks that are divided into two groups of two. Each group of cam locks opens with a specific key number. All open with the same master key.

These highly pick-resistant locks have specially designed half-moon keys that cannot be duplicated.

Also known as compression cam locks, turn the handle a quarter-turn to latch, then another quarter-turn to draw the cam firmly against the door or drawer surface.

The mounting screws on these locks are concealed to prevent tampering.

In addition to an IP65 rating for washdown environments, these locks have a squeeze-release handle to prevent accidental opening when unlocked.

Choose these locks if you need each one to open with a different key.

The mounting screws on these locks are concealed to prevent tampering.

With a molded inset grip, the handle remains recessed to stay out of the way.

These tight-hold locks are IP65 and NEMA 4 rated for protection against dust, dirt, and washdowns. Press the button and the handle snaps open; push the handle shut for a secure hold.

Set a combination and reset it at any time.

Choose these hasps if you need hasps that each open with a different key.

Choose these cylinders if you need cylinders that each open with a different key.