Use with T-slot nuts or bolts and a support to secure a workpiece, vise, or fixture to a machine table.

Instead of a step block, support these clamps using a screw, leveling mount, or any other threaded object.

Good for occasional machining, economy kits contain lower-strength components than standard kits.

Use these blocks to support setup clamps. Fit the nonslip steps together for quick height adjustments.

A plastic pad on the gripping surface of these clamps prevents workpiece marring, making them useful for holding polished surfaces and reducing the need for secondary finishing steps.

Keep setup clamps from falling out of position when they are unclamped—the spring holds them up for quick workpiece insertion and removal. Also known as spring lifters.

Making minimal contact with the workpiece while holding securely, these clamps are good for small parts and can clamp into holes and notches.

Use these clamps to hold large round parts for machining. Each clamp comes with five lengths of chain that combine to accommodate different size workpieces.

Smaller than standard setup clamps, these clamps leave more usable space on a machine table when mounting a vise.

Build these components into fixture plates, machine subplates, and tombstones for quick changes. The system clamps and locates at the same time for accurate positioning with repeatability of ±0.0005".

Secure a workpiece from the inside, leaving the outside clear for machining.

Set one of these clamps between two workpieces in a fixture and tighten the screw to push the clamp's sides out for a secure hold.

Machine these clamps to match the contours of your workpiece and turn the screw to grip.

Machine these fixture clamps to match the contours of your workpieces for a stronger grip. Place the clamp between the two workpieces in a fixture and tighten the screw to extend the sides of the clamp, creating a secure hold against both workpieces.

Machine these fixture clamps to match the contours of your workpiece for a stronger grip.