Set a desired torque within the range.

Prevent overtightening that can damage fasteners. These adapters spring back slightly when the set torque is reached.

These wrenches slip to disengage and stop turning the fastener when the set torque is reached, preventing overtightening.

Set the desired torque and the wrench indicates when it's reached with an audible click and an impulse in the grip.

No need to pull the socket off the tool—push a button to release.

Made of beryllium copper, these wrenches satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Set torque and the wrench will prevent you from exceeding it. These are also known as nutrunners.

Set the desired torque and the driver indicates when it's reached.

Also known as ESD-safe screwdrivers, the handle drains static away from your application, preventing buildup from electrostatic discharge (ESD) that can damage sensitive equipment. When set torque is reached, these drivers slip to disengage and prevent overtightening.

Set includes a handle and six shafts. Remove and replace the shaft to use a different size or drive style.

Attach a socket to the 1/4" square drive tip to turn hex nuts and hex head screws. When set torque is reached, these drivers signal with an audible click.

The motor shuts off when the set torque is reached to prevent overtightening and damaging fasteners. These tools provide the most torque control of any electric screwdriver.

Reach the same torque every time with factory-set screwdrivers that slip to disengage and stop turning the fastener when the set torque is reached, preventing overtightening.

Turn the handle like a standard torque driver and the 90° offset head reaches fasteners in tight spots. Factory-set screwdrivers ensure you reach the same torque every time.

Ensure carbide inserts are tightened to the correct torque. These tools are set to the recommended torque values for each screw size.

A dial shows how torque measurements change as you turn the driver. Use these tools to fasten to a specific torque, determine fastener torque specifications, and identify the torque required to loosen tightened fasteners.

A green light and a beep alert you when you've reached 90% of your set torque, and a steady tone sounds once you've hit your target. Set your torque in cNm, cm-Kg, or in.-lbs. and quickly check the LCD for real-time measurements along the way. A red light warns if you begin to overtighten.

If they exceed maximum torque, these couplings disengage, sound an alarm, and then automatically re-engage once the overtorque condition is eliminated.

To protect power-transmission components from damage, these couplings will shear or tear in overtorque conditions (approximately 10-20 times the maximum rated torque) to sever connections between shafts.