Clear All
    System of Measurement
    System of Measurement
    Inch
    Metric
    For Use On
    For Use On
    Show
    Aluminum
    For Use On
    For Use On
    Hide
    Warning: Products have one, but not necessarily all, of the selected characteristics.
    Copper
    Brass
    Steel
    Stainless
    Steel
    Aluminum
    Titanium
    Plastic
    Maximum Bending Angle
    Maximum Bending Angle
    90°
    120°
    180°
    Material
    Material
    Steel
    Aluminum
    Iron
    Power Source
    Power Source
    Manual
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Mandrel Material
    Mandrel Material
    Steel
    Aluminum
    Iron
    Iron/Aluminum
    Mounting Location
    Mounting Location
    Bench Top
    Vise
    Width
    Width
    4"
    4 1/4"
    4 3/4"
    Die Diameter
    Die Diameter
    1/2"
    3/4"
    1"
    1 1/4"
    1 1/2"
    2"
    3"
    4"
    Mounting Hole Diameter
    Mounting Hole Diameter
    3/8"
    9/16"
    Number of Mounting Holes
    Number of Mounting Holes
    2
    3
    For Maximum Wire Diameter
    For Maximum Wire Diameter
    3/8"
    Height
    Height
    3 1/2"
    10"
    For Maximum Rod Diameter
    For Maximum Rod Diameter
    3/8"
    For Maximum Flat Stock Thickness
    For Maximum Flat
    Stock Thickness
    3/16"
    Base Length
    Base Length
    3"
    6"
    Base Width
    Base Width
    3"
    4"
    Handle Length
    Handle Length
    12"
    16"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    42 Products