Also known as NC tolerance end mills, these carbide end mills have oversize mill diameter tolerances. They're sized to match standard high-speed steel end mills, so you can use them as longer-lasting replacements without changing the size of the cut.

These end mills have a diamond or diamondlike coating for machining abrasive material, such as carbon fiber, fiberglass, and graphite.

Use these end mills for short runs and general purpose milling in most material, such as aluminum, brass, bronze, iron, and steel.

With a higher helix angle than standard high-speed steel end mills, these clear more chips and generate less heat, making them good for milling soft material, such as aluminum, brass and bronze.

With better heat and wear resistance than high-speed steel, these cobalt steel end mills can run at higher speeds and provide better performance on hard material, such as iron, hardened steel, titanium, and tool steel.

These end mills have a diamond or diamondlike coating for machining abrasive material, such as carbon fiber, fiberglass, and graphite.

A titanium-carbonitride (TiCN) coating prevents soft material, such as aluminum, brass, and bronze, from accumulating on the cutting edge and creating an uneven finish.

Use these end mills for general purpose milling in most material, such as aluminum, brass, bronze, iron, and steel.

When one end wears out, switch to the opposite end for two times the life of a standard high-speed steel end mill. Made of high-speed steel, these end mills are for general purpose milling in most material, such as aluminum, brass, bronze, iron, and steel.

With better heat and wear resistance than high-speed steel, these cobalt steel end mills can run at higher speeds and provide better performance on hard material, such as iron, hardened steel, titanium, and tool steel. When one end wears out, turn the tool around for a sharp edge.

Made of cobalt steel, these end mills have good heat and wear resistance, so they can run at high speeds in hard material. A 90° pointed tip allows them to be used for drilling as well as for slotting, profiling, chamfering, and spotting cuts.

Offering two times the life of a standard end mill, these have two milling ends so you can switch to the opposite end when one end wears out. Use them for general purpose milling in most material, such as aluminum, brass, bronze, iron, and steel.

Offering two times the life of a standard carbide end mill, the end mills in these sets have two milling ends so you can switch to the opposite end when one end wears out. Made of solid carbide, they're harder, stronger, and more wear resistant than high-speed steel for the longest life and best finish on hard material.

The end mills in these sets have one milling end and a standard shank. Made of solid carbide, they're harder, stronger, and more wear resistant than high-speed steel for the longest life and best finish on hard material.

Use these end mills for general purpose milling in most material, such as aluminum, brass, bronze, iron, and steel.

Cut square slots, pockets, and edges in plastic.

The aluminum-titanium-nitride (AlTiN) coating on these bits resists heat and wear when cutting steel and stainless steel. They have a square cut style for creating slots, pockets, and edges.

For smooth contour carving in wood, plastic, and aluminum, these bits have a ball-nose design.

These bits have a straight cutting edge for flush trimming and an angled cutting edge for making 22° chamfer cuts. They're for use on countertops and other plastic laminate material.

These bits make chamfer, bevel, and other angled cuts in wood.

These tools create a wide, shallow cut on the face of the workpiece. They're often used to level spoilboard so it lies perfectly flat for accurate routing and milling.