The V‐shaped recess holds round material securely for machining.

Significantly cut down on jaw changeover time—this two-part system lets you swap out jaws in less than 30 seconds. Mount the jaw plates to the vise and slide the dovetailed jaw stock in and out of the plates.

Hold workpieces steady with these vise jaws—they work with slot-mount workstops so you can quickly position, adjust, and change out your workpieces.

Use these vises for reliable workholding on CNC machines.

Mount to a machine table to rotate a vise 360° in 1° increments.

Maintain your vise by replacing seals, springs, and other commonly worn parts.

The small size allows multiple vises to be mounted on a single machine table. Frequently used in 4- and 5-axis milling machines, these vises have stepped jaws with serrated teeth that firmly grip just a small portion of your workpiece.

No need to prepare this material before machining parts in dovetail vises—the dovetails and locating slots are already cut in.

Push the handle to slide the jaw into place for quicker setup than standard drill-press vises.

The dials on these vises are graduated in smaller increments than standard cross‐slide drill‐press vises for finer adjustment. Use to precisely position work on X and Y axes.

Tilt and lock the vise to hold work at any angle up to 90°.

Attach these workstops to the side or top of your vise to keep parts in position for machining.

Tilt the head on two axes and rotate the base to position your workpiece at almost any angle.

Compressed air controlled by a foot pedal allows hands‐free operation. Use these vises in production applications with frequent insertion and removal of workpieces.

The entire surface of these plates is magnetic to provide a powerful hold for grinding, drilling, and electrical discharge machining (EDM). Pull the handle to switch the magnets on and off.

For large workpieces, these vises open three times as wide as standard tilting-head vises. Tilt and lock the head to position work at an angle.

Rotate the head 360° to use three different vise jaws and lock workpieces in position at 45° intervals.

For big jobs, these vises have a wider jaw opening, deeper throat depth, and larger footprint than standard vises.

A bright yellow vise body stands out on the shop floor.

The movable jaw can be repositioned to extend the jaw opening. Pull out the entire sliding section and insert it on the opposite side of the vise.

Insert these one-piece grooved liners between vise jaws to hold small-diameter material vertically.

These V-shaped liners hold large round material.

Place over the jaws and tighten the screws to securely attach liners.

Also known as woodworkers' vises, these mount to the underside of your workbench and sit flush with the surface.

Hold your smallest workpieces in these vises, which have a clamp-on base for quick installation and removal from a benchtop.

Notches on the jaws hold round material on its outside diameter.

Sets include four vises with different opening sizes. A hollow body allows wires and rods to pass through.

Each end of the vise has a collet to hold a different tool—turn the collar to close the collets around them.

A rubber-covered body provides a comfortable grip. These vises have a rotating end cap on the handle that allows you to apply constant pressure while turning the body of the vise with your fingertips.

Jaw are serrated or grooved to firmly grip workpieces.

Three chuck-style jaws clamp around your part.

Steel jaws secure round workpieces such as pipe, tubing, and conduit.

Set up the tripod wherever you need to work.

Build a custom clamping system for holding lightweight objects such as beakers and laboratory equipment.