These standoffs are designed to fit in the limited space of compact electronics such as laptops and hand-held devices.

Once the end is clinched in place, panels with keyholes easily slide on and off these supports.

Thread the male connection into a tapped hole and snap the other end into a panel for a secure hold that can be released for repairs and upgrades.

The ends of these removable supports snap in and compress between panels to reduce vibration of miniature cooling fans in compact electronics.

Both ends snap and lock in place for a permanent connection.

Wings add tension to strengthen the hold in a hole. The other end is releasable for repairs and upgrades.

Use these barrels with a screw you already have or pair with a different type of screw to create a custom fastener. Made from 18-8 stainless steel, they are chemical resistant.

Pair these screws with a barrel you already have or couple with a different barrel to create a custom fastener. Made from 18-8 stainless steel, they are chemical resistant.

These include a barrel and a screw with an extra-wide (truss) head. Made from 316 stainless steel, they have excellent chemical resistance and can be used in saltwater environments.

Use these barrels with a screw you already have or pair with a different type of screw to create a custom fastener. They're zinc plated to resist corrosion in wet environments.

Shorter than shoulder screws for use in thin material.

Use these hex drive screws and binding barrels as a low-profile alternative to standard nut and bolt combinations.

Add length to a binding barrel.

Brass binding barrels and screws are corrosion resistant in wet environments and electrically conductive.

An unthreaded barrel allows quick assembly with a press or a hammer.

These barrels and caps are corrosion resistant in wet environments.

Angled under the head for a flush finish in countersunk holes.

These binding barrels and screws have good chemical resistance.

More corrosion resistant than 18-8 stainless steel binding barrels and screws, these have excellent resistance to chemicals and salt water.

These bollards flex slightly when bumped by a vehicle to prevent dents and dings.

Combine rails, posts, and gates to make a custom guardrail system.

During light collisions, these guardrails tilt to absorb impact and minimize damage to a vehicle.

Start with two bases and then stack rails to the desired height.

Instead of a post, use these rings to hang chain between metal surfaces.

Provide an end point for a belt barrier.

To make a complete unit, team one or more belt barriers with a wall receptacle or receiver post.

Mark equipment at risk of being hit by vehicles.

Stand panels up to create enclosures without sinking posts into the ground.

Support trench walls when installing pipes, cables, and other buried equipment.

Drive these posts into the ground or use them with a base.

Reduce damage to signs, parking lot surfaces, and vehicles, these posts rebound after contact.

Drive these stakes into the ground and then slide a foam or corrugated plastic sign over the top.

Communicate two- or four-way stops with one freestanding stop sign.

Reflectors are visible from both sides for areas where traffic moves in two directions.

Rails are drilled with consistently spaced holes for multiple mounting options that do not require machining. Use this steel bolt-together framing to build guards, tables, and racks.

Support beams and joists.

Give open-ended standoffs a finished look and protect them from dirt and debris.

Before making a permanent connection, use these connectors to test a circuit. Also known as binding posts, they mount through panels to create a connection point.

Distribute up to 150 amps from the center stud terminal to the eight screw terminals around it.

Replace battery terminal hardware.

Four flat head screws lock down round-shank tools in a precision-ground bore for increased rigidity over other round-shank tool holders.

A built-in drill chuck allows quick installation of drill bits, taps, and other round- or hex-shank tools into a quick-change tool post.

Two slide-in dovetail mounts on the tool posts allow you to quickly change from one tool holder to another.

Mount any tool with a Morse taper shank to a quick-change tool post.